MARK OUT ASSIGNMENT- PART 3.

NAME: Total marks 15 Mark:

READING INSTUMENTS

Job HT 7 Mark out of 5 Mark:

Scribe out the rhombus as shown below (whose sides are all 50 mm and set in 10mm from the forward edge, to which it is angled at 45) on top & bottom of a plate / plank in preparation for cutting out.

 

Scribe out the circles as shown below (whose diameters are all 25 mm, are 25 mm apart and set in 25mm from the forward edge) on top & bottom of a plate / plank in preparation for cutting out.

 


How could you check if top and bottom marks are aligned before cutting out?

Now record the measure in mm is that is indicated by the measuring instruments described on the following pages:

Check your answers