CHECK YOUR PROGRESS NAME:
ENGINEERING 3 (printable pdf) (answers)
VIEW
TDMMR3007B 1 Operate and carry out basic service checks on small vessel marine propulsion systems
TDMMR3107B 2 Operate and carry out basic servicing on auxiliary systems
TDMMR3207B 3 Operate and carry out basic routine servicing of marine extra low/low voltage electrical systems
Question 1 (1 Mark) Validates to TDMMR3207B element 1a
Electricity can be generated electro-chemically and electro-magnetically. |
|
TRUE |
FALSE |
Question 2 (1 Mark) Validates to TDMMR3207B element 1a
The electrolyte in a lead-acid battery is?
a. hydrochloric acid
b. sulphuric acid
c. diluted nitric acid
d. diluted sulphuric acid
Question 3 (1 Mark) Validates to TDMMR3207B element 1a
Match the term with the description:
1. Conductor |
a. The opposition to current flow |
|
2. Insulator |
b. Allows current to move through it |
|
3. Fuse |
c. Will not allow current flow |
|
4. Resistance |
d. Will melt with current overload |
Question 4 (1 Mark) Validates to TDMMR3207B element 1a
Name the components of the simple circuit labelled below:
A=_______________________ B=_______________________
C=_______________________ D=_______________________
E=_______________________
Question 5 (1 Mark) Validates to TDMMR3207B element 1a
Match the term with the description:
1. Volt |
a. A unit of electrical resistance |
|
2. Amp |
b. A unit of electrical potential difference |
|
3. Watt |
c. A unit of electrical current flow |
|
4. Ohm |
d. A unit of electrical power |
Question 6 (1 Mark) Validates to TDMMR3207B element 1a
The lead acid battery shown below has six two volt cells internally connected in
series. The voltage available from this charged battery is _____________ volts.
Question 7 (1 Mark) Validates to TDMMR3207B element 1a
Draw the electrical leads, correctly connected, that will be required to fully light the test 12 volt light globe from two 12 volt batteries shown below.
Question 8 (1 Mark) Validates to TDMMR3207B element 1a
This circuit in Question 7 is said to be a series circuit. |
|
TRUE |
FALSE |
Question 9 (1 Mark) Validates to TDMMR3207B element 1a
Draw the electrical leads, correctly connected, that will be required to fully light the test 24 volt light globe from two 12 volt batteries shown below.
Question 10 (1 Mark) Validates to TDMMR3207B element 1a
These circuits are said to be a series/parallel circuits. |
|
TRUE |
FALSE |
Question 11 (1 Mark) Validates to TDMMR3207B element 1b
Batteries should be installed in a vessel:
a. high up above the water line in case of swamping
b. low down to increase the stability of the vessel
c. where they can be vented to the atmosphere
d. at a height where they are easily checked avoiding back injuries
Question 12 (1 Mark) Validates to TDMMR3207B element 1b
When a fuse blows you should replace it with:
a. a higher capacity fuse
b. a lower capacity fuse
c. the same capacity fuse
d. a piece of rolled up silver foil
Question 13 (1 Mark) Validates to TDMMR3207B element 1b
If the battery leads of a small vessel’s 12 volt electrical circuitry were reversed
a. the fuses would blow
b. it does not matter
c. electrical motors will operate normally but the radio won’t
d. electrical system damage and personal injury may result
Question 14 (1 Mark) Validates to TDMMR3207B element 1c
The instrument shown below is called a_______________________.
It is used for_____________________________________________.
Question 15 (1 Mark) Validates to TDMMR3207B element 1c
The specific gravity of a battery cell that is fully discharged is described as:
a. 1100
b. 1250
c. 1150
d. 1200
Question 16 (1 Mark) Validates to TDMMR3207B element 1d
The 240 volt switching unit shown below indicates that there is current in the shore power line. Describe the procedures to switch over to the vessel’s generator set:
STEP 1____________________________________________________
STEP 2____________________________________________________
STEP 3____________________________________________________
STEP 4____________________________________________________
Question 17 (1 Mark) Validates to TDMMR3207B element 1d
When connecting shore power at a jetty in the rain, great care must be taken to fully insert the plug before switching on the electrical socket because:
a. you could slip
b. the plug may be swollen and not fit properly
c. the damp may act as an insulator
d. you could be electrocuted
Question 18 (1 Mark) Validates to TDMMR3207B element 2a
If the ammeter reads negative and the voltmeter is dropping a likely cause is a:
a. slipping alternator drive belt
b. over revving alternator
c. open circuit
d. flat battery
Question 19 (1 Mark) Validates to TDMMR3207B element 2a
Moving machinery pulleys and drives must be fitted with a ________________.
Question 20 (1 Mark) Validates to TDMMR3207B element 2b
If an alternator diode fails the voltage indicator will read zero. |
|
TRUE |
FALSE |
Question 21 (1 Mark) Validates to TDMMR3207B element 3a
The gas given off by a battery when it is being charged is?
a. explosive
b. ozone
c. chlorine
d. toxic
Question 22 (1 Mark) Validates to TDMMR3207B element 3b
Salt water used to top the battery electrolyte if nothing else is available. |
|
TRUE |
FALSE |
Question 23 (4 Marks) Validates to TDMMR3207B element 3c
With reference to confined spaces, match the description on the right, with the correct item on the left:
1. Isolation |
a. Physical barriers erected to prevent entry |
|
2. Lockout |
b. Issued only by a competent person |
|
3. Gas free certificate |
c. Removal of all services into a space |
|
4. Permit to work |
d. Required conditions of entry |
Question 24 (1 Mark) Validates to TDMMR3207B element 3d
The switches on the 240 volt panel shown below are called_______________.
Question 25 (1 Mark) Validates to TDMMR3207B element 3d
Faulty electrical equipment must be_______________and________________:
Question 26 (1 Mark) Validates to TDMMR3207B element 3d
Of the three battery switches at the bottom of this 24 volt switch board the middle
one is only used to_____________________________________________.
Question 27 (4 Marks) Validates to TDMMR3207B element 3e
A fire control plan is summarised by the phrase to FIRE- Find the problem, Inspect/isolate it, Report and the Extinguish. Write a brief plan for the damage that I have found for you. |
|
F |
An electrical fire has broken out in the 240 volt switchboard. |
I |
___________________________________________________________ ___________________________________________________________ |
R |
___________________________________________________________ ___________________________________________________________ |
E |
___________________________________________________________ ___________________________________________________________ |
Ranger Hope © 2008 (contains reworked material courtesy of ANTA)