HAND TOOLS EXERCISES & ASSIGNMENTS

Contains extracts courtesy of A.N.T.A publication’s, TAFE “Electrical trades -Tools & Equipment Pt 1” & Trowbridge Technical CollegeCarpenry & Joinery Trade Notes” 

(Link to power tools)

First read the hand tools workbook

Exercises:

Exercise One-     Spanners & wrenches

Exercise Two-      Screwdrivers & pliers

Exercise Three-    Hammers

Exercise Four-      Punches, chisels & hacksaws, tool identification

Sample of Job Documentation Records:

No 1     What measurement devices are used in an engineering workshop. Describe their use.

No 2       Identify the hand tools you would use to accurately mark out a component.

No 3      How would you strip, inspect and reassemble a piece of machinery (e.g. Jabsco pump, gear       box, fuel pump, outboard, alternator, starter motor, etc.) 

Assignments, Assessment & Practical Activities:

No 1     Marking out and measuring simple engineering components:

No 2     Producing a component using hand tools:

No 3     Dismantled/re-assembled a component using tools:

Sample Written Assessment:


List of Jobs:

Job HT 1  Use of Feeler Gauges                        Job HT 2 Use of Radius Gauges

Job HT 3  Use of Screw Pitch Gauges               Job HT 4 Use Form Gauges

 

Job HT 5  Use of Thickness Gauges                  Job HT 6 Use of Rule Measurements

Job HT 7   A scaled drawing                               Job HT 8 Making a small component

Job HT 9   Hole cutting exercise                       Job HT 10 Making a small component

 

Job HT 11  Making aTube Spanner                   Job HT 12 Dismantling and Assembly

Job HT 13  Measure a part                                 Job HT 14 Dismantling and Assembly

Assessment:

THE STUDENT PERFORMED THE TASK OF:

RESULT

CIRCLE METHOD

Event 1 - Measuring simple engineering components:
Measured components using standard gauges to an accuracy of + or - 0.1mm.
                           
Measured components using basic graduated measuring devices.
                        
Checked, adjusts and stores graduated devices appropriately.

 

Observation and question 

Assignment               Link

Written test

Workplace observation

 Event 2- Producing a component using hand tools:

Identified hand tools used to manufacture components.


Selected / used appropriate hand tools to mark out a specified component.

Selected / used appropriate hand tools to manufacture the above component.
                           
Manufactured the above component to within the tolerances specified on an engineering drawing.
                       
Maintained repair and store tools appropriately.
                           

 

Observation and question

Assignment                Link

Written test

Testimonial

Workplace observation

Event 2- Dismantled/re-assembled a component using tools:
Identified hand tools used to dismantle and assemble engineering components.
                           
Selected and use appropriate hand tools to dismantle an assembly without damaging the components or tools.


Recorded the sizes of components from the assembly.
                           
Selected and use appropriate hand tools to re-assemble the assembly without damaging the components or tools.

 

Observation and question

 Assignment                 Link

Written test

Testimonial

Workplace observation

The Students demonstrated acceptable behaviour and maintained workplace safety standards at all times during assessment to comply with OH&S requirement.

Yes    No

Acceptable